Ricoh M022 Service Manual page 785

Feed Condition
Selects the paper feed timing.
0: Productivity priority, 1: Fusing quality priory
Note:
When the print paper size changes from a small to a large size, you can stop the print job
001
in order to ensure that the fusing temperature is high enough, and then resume it when the
proper temperature has been reached.
This mode is used on machines in which the fusing ability is low, for example when there is
one fusing lamp. And it is mainly used on A3 MFPs which change repeatedly between A3
and A4 size. However, it is not used on machines in which there are two heating lamps, such
as A4 MFPs which almost never change between A4 and A5.
1121 [Maximum Duty Switch] DFU
Control Method Switch
Selects the power control method for the fusing unit.
0: Fixed control, 1: Power control
001
The machine is used over the rated voltage of PSU. For example, 1700w can be used at the
machine of 1500w. When the fusing ability is too low early morning, or the electrical power
environment is not stable, this switch can be used. However, there is a risk of over-voltage
when using this SP, since it is not used under normal conditions.
1159 [Fusing Jam Detection]
SC Display
001
Enables or disables the fusing consecutive jam (three times) SC detection.
0: No detection, 1: Detection
1201 [CPM Down Setting] DFU
001 Low: Down Temp.
002 Low: Up Temp.
003 Low: 1st CPM
004 Low: 2nd CPM
005 Low: 3rd CPM
CÓPIA NÃO CONTROLADA
*ENG [0 or 2 / 0 / 1]
*ENG [0 or 1 / 1 / 1]
*ENG [0 or 1 / 0 / 1]
*ENG
*ENG
*ENG
*ENG
*ENG
CÓPIA NÃO CONTROLADA
[-50 to 0 / -10/ 1 deg/step]
[-50 to 0 / -7/ 1 deg/step]
[10 to 100 / 80 / 5 %]
[10 to 100 / 65 / 5 %]
[10 to 100 / 50 / 5 %]
System SP-xxx
3
39