Ricoh M022 Service Manual page 781

After Job End
002
Specifies the idling time without the lamp on after job end.
This idling prevents the heating roller overheating after job end.
1118 [Curl Correction]
Execute Pattern
Selects the curl correction mode.
0: Invalid
1: 600 dpi
2: 1200 dpi
001
3: 600/1200 dpi
• This SP is not effective for all curl situations. Use this SP if you see a sharp back curl after
the machine recovered from "OFF mode" in a high temperature and humidity
environment.
Humidity Thresh 1
002
Specifies the first threshold humidity for executing the curl correction.
Humidity Thresh 2
003
Specifies the second threshold humidity for executing the curl correction.
004 Pattern 1: MM: H-Roll
005 Pattern 1: MM: P-Roll
006 Pattern 1: HM: H-Roll
007 Pattern 1: HM: P-Roll
008 Pattern 2: MM: H-Roll
009 Pattern 2: MM: P-Roll
010 Pattern 2: HM: H-Roll
011 Pattern 2: HM: P-Roll
1119 [Fusing FF Control] DFU
CÓPIA NÃO CONTROLADA
ENG [0 to 10 / 5 / 1 sec/step]
*ENG [0 to 4 / 0 / 1]
*ENG [0 to 100 / 65 / 1 %]
*ENG [0 to 100 / 80 / 1 %]
*ENG [-30 to 0 / -3 / 1 deg]
*ENG [0 to 60 / 0 / 1 deg]
*ENG [-30 to 0 / 0 / 1 deg]
*ENG [0 to 60 / 0 / 1 deg]
*ENG [-30 to 0 / -5 / 1 deg]
*ENG [0 to 60 / 50 / 1 deg]
*ENG [-30 to 0 / -5 / 1 deg]
*ENG [0 to 60 / 50 / 1 deg]
CÓPIA NÃO CONTROLADA
System SP-xxx
3
35