Ricoh M022 Service Manual page 188

4. Replacement and Adjustment
6. Execute SP2-180-004 for clearing main scan start position adjustment setting.
7. Execute SP2-153-001 for clearing LD power.
8. Exit the SP mode.
9. Turn off the main power switch and disconnect the power cord of the copier.
Recovery procedure for no replacement preparation of laser unit
If you did not do the procedure in "Before removing the old laser unit" before removing the laser unit, you
must do the following.
1. Turn off the main power switch and disconnect the power cord of the copier.
4
2. Left cover (
3. Disconnect the harness [A] of the skew correction motor.
4. Do steps 1 to 9 of "Before removing the old laser unit".
5. Connect the harness [A] and reassemble the machine.
6. Plug in and turn on the main power switch.
Removing the laser unit
1. Left cover (
186
CÓPIA NÃO CONTROLADA
p.146)
p.146)
CÓPIA NÃO CONTROLADA