Reinstalling the Front Scanner Wire
1. Position the center ball [A] in the middle of the forked holder.
2. Pass the right end (with the ball) [B] through the square hole. Pass the left end (with the ring) [C] through
the notch.
3. Wind the right end counterclockwise (shown from the machine's front). Wind the left end clockwise.
• The two blue marks [D] come together when you have done this. Stick the wire to the pulley with
tape. This lets you easily handle the assembly at the time of installation.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA
Scanner Unit
4
177