Ricoh M022 Service Manual page 802

3. Appendix: SP Mode Tables
003 Execute:Mode c
004 Execute:Mode d
2112 [ID Sensor Test] ID Sensor Check FA
3
001 Execute
[Skew Adjustment]
2117
Specifies a skew adjustment value for the skew motor M, C or Y.
001 Pulse: C
002 Pulse: M
003 Pulse: Y
2118 [Skew Adjustment]
001 Execute: C
002 Execute: M
003 Execute: Y
[Skew Adjustment Display]
2119
Displays the current skew adjustment value for each skew motor.
001 C
002 M
003 Y
56
CÓPIA NÃO CONTROLADA
Executes the rough line position adjustment once.
After doing this SP, make sure to execute
-
SP2111-001 or -002. Otherwise, the line position
adjustment is not perfectly done.
- Rough adjustment and fine adjustment, once each.
This SP is used to check the ID sensors at the factory.
The results of this SP are displayed in SP2140 to
SP2145.
*ENG
*ENG [–100 to 100 / 0 / 1 pulse/step]
*ENG
*ENG
Changes the current skew adjustment values to the
*ENG
values specified with SP2117.
*ENG
*ENG
*ENG [–75 to 75 / 0 / 1 pulse/step]
*ENG
CÓPIA NÃO CONTROLADA