Ricoh M022 Service Manual page 783

[FF Correct Time]
FF Correct Time
025
Specifies the FF duty correction time after the fusing/ paper exit motor has started to rotate
in each print mode.
[FF Control thresh]
Specifies the offset temperature for turning off the FF duty correction.
026 Offset:Center
027 Offset:End
[FF Start Time]
Specifies the start time of the FF duty correction after FGATE has been "ON".
028 Fgate Timer:FC:Std
029 Fgate Timer:FC:Low
030 Fgate Timer:BW:Std
031 Fgate Timer:BW:Low
[FF Correct Time]
Specifies the additional time to the FF duty correction time for each lien speed.
Full: Full speed, Half: Half speed
032 Time Set:Std
033 Time Set:Low
[Fgate Timer]
Specifies the additional duty to the heating roller fusing lamp for each paper type. These values are
added to the duty decided by the PID control.
034 FC:Middle
035 BK:Middle
[Correct Time Set]
036 Middle
CÓPIA NÃO CONTROLADA
*ENG [0 to 60 / 5 / 1 sec]
*ENG
[0 to 50 / 25 / 1 deg]
*ENG
*ENG [0 to 10000 / 400 / 1msec]
*ENG [0 to 10000 / 3700 / 100msec]
*ENG [0 to 10000 / 0 / 100msec]
*ENG [0 to 10000 / 800 / 100msec]
*ENG
[-5000 to 5000 / 0 / 100msec]
*ENG
*ENG [0 to 10000 / 1000 / 100msec]
*ENG [0 to 10000 / 0 / 100msec]
*ENG [-5000 to 5000 / 0 / 100msec]
CÓPIA NÃO CONTROLADA
System SP-xxx
3
37