Ricoh M022 Service Manual page 438

5. System Maintenance
002 Relative Humidity
003 Absolute Humidity
[Execution Interval: Display]
Displays the current interval for process control execution.
3515
When the machine calculates the timing for process control, it uses a number of conditions.
These are the results after considering all the conditions.
001 Job End: Process Control: BW
002 Job End: Process Control: FC
003 Interrupt: Process Control: BW
5
004 Interrupt: Process Control: FC
[Blade Damage Prevention Mode]
Adjusts the threshold temperature for preventing the cleaning blade in the transfer belt
3517
cleaning unit from being damaged. If the temperature is above this value, toner is applied
to the transfer belt at set intervals during the job to prevent the blade from flipping over.
001 Execution Temp. Thresh
[Toner End Prohibition Setting]
3519
Enables or disables each adjustment at toner end.
001 Process Control
002 MUSIC
003 TC Adjustment
[Initial Process Control Setting]
Adjusts the threshold for the process control at power on.
3522
When the current condition has changed by more than the values of these SPs when
compared with the conditions at the previous operation, the process control at power on is
executed.
436
CÓPIA NÃO CONTROLADA
*ENG [0 to 1000 / - / 0.1%RH/step]
*ENG [0 to 1000 / - / 0.1 g/cm
*ENG
*ENG
*ENG
*ENG
*ENG
*ENG [0 or 1 / 1 / 1/step]
0: Permit (adjustment is done even toner end
*ENG
condition)
1: Forbid (adjustment is not done at toner end
*ENG
condition)
CÓPIA NÃO CONTROLADA
3
/step]
[0 to 2000 / 500 / 1 page/step]
[0 to 2000 / 200 / 1 page/step]
[0 to 2000 / 500 / 1 page/step]
[0 to 2000 / 200 / 1 page/step]
[0 to 50 / 0 / 1 deg/step]