Link Aggregation Commands - D-Link xstack DGS-3612G Instruction Manual

The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
create link_aggregation group_id
delete link_aggregation group_id
config link_aggregation group_id
config link_aggregation algorithm
show link_aggregation
config lacp_port
show lacp_port
Each command is listed, in detail, in the following sections.
create link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a link aggregation group:
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
<value 1-32> {type [lacp | static]}
<value 1-32>
<value 1-32> {master_port <port> | ports <portlist> state [enable
| disable]}
[mac_source | mac_destination | mac_source_dest | ip_source |
ip_destination | ip_source_dest]
{group_id <value 1-32> | algorithm}
<portlist> mode [active | passive]
{<portlist>}
Used to create a link aggregation group on the Switch.
create link_aggregation group_id <value 1-32> {type [lacp | static]}
This command will create a link aggregation group with a unique identifier.
<value> − Specifies the group ID. The Switch allows up to 32 link
aggregation groups to be configured. The group number identifies each of
the groups.
type – Specify the type of link aggregation used for the group. If the type is
not specified the default type is static.
•
lacp – This designates the port group as LACP compliant. LACP
allows dynamic adjustment to the aggregated port group. LACP
compliant ports may be further configured (see config lacp_ports).
LACP compliant must be connected to LACP compliant devices.
•
static – This designates the aggregated port group as static. Static
port groups can not be changed as easily as LACP compliant port
groups since both linked devices must be manually configured if
the configuration of the trunked group is changed.
Only administrator-level users can issue this command.
DGS-3612G:4#create link_aggregation group_id 1
Command: create link_aggregation group_id 1
Success.
DGS-3612G:4#
L A
INK GGREGATION
116
16
C
OMMANDS