Table of Contents
Advertisement
A
•
Exit Pinch Roll
•
Document Belt
Enter dC330 005-115 Exit Sensor. Press Start. Block the DADF Exit Sensor. The
changed from L to H.
Y
N
With paper at the DADF Exit Sensor, less than +1 VDC is measured at P/J599-19 on
the DADF Control PWB.
Y
N
+5 VDC is measured between P/J589-1 and P/J589-3 on the DADF Exit Sen-
sor.
Y
N
Go to
Flag 3
BSD 5.5. Check the wires for an open circuit or a short circuit. If
the wires are good, replace the DADF Control PWB
Go to
Flag 1
on BSD 5.5. Check the wire for an open circuit. If the wire is good,
replace the DADF Exit Sensor
(PL
Replace the DADF Control PWB
(PL
Check the following parts for wear slipping or damage.
•
Exit Roll Drive Belt
•
Exit Roll
•
Exit Pinch Roll
•
Document Belt
•
Platen Glass
If the above items are good and free from excessive contamination, replace the DADF Exit
Sensor
(PL
12.9).
Status Indicator RAPs
5-116 DADF Exit Sensor OFF Dynamic Jam RAP, 5-
(PL
12.3).
12.9).
12.3).
5-189 No Object Sensor Static Jam RAP
The Control Logic has detected the document Handler was raised while running a DADF job.
display
Initial Actions
Ensure that then document handler is fully closed.
Procedure
If the document Handler was not opened during a DADF job, go to
RAP
to troubleshoot the Platen Open Switch.
1/05
2-44
manuals4you.com
manuals4you.com
6-300 Platen Cover Open
Reissue
DocuColor 12/DCCS50
Advertisement
Table of Contents
Troubleshooting
