Feeder; Manual Feed No Paper Sensor - Xerox Phaser 6128MFP Service Manual

Hide thumbs Also See for Phaser 6128MFP:

Table of Contents

Feeder

Phaser 6128MFP Service Manual

To help prevent damage to the Transfer Belt while removing the sensor, place

a sheet of paper on the Transfer Belt.

1. Open the Front Cover.

2. Remove the Imaging Unit (page 8-8).

3. Remove 2 screws (silver, tap, 8mm) that secure the bracket, and lift.

4. Release 3 hooks that secure the sensor to the bracket. Release the harness

wires from the restraint on the bracket and set the bracket aside.

5. Unplug the sensor from the harness connector (P/J233).

Replacement Note

When installing a new sensor:

1. Plug the sensor into harness connector.

2. Install the sensor into the bracket. Tip: insert the end hook first, then

snap the side hooks in place.

3. Route the harness wires into the restraint in the bracket.

4. Set the bracket in place and secure it with the two screws.

Service Parts Disassembly

s6128mfp-270

s6128mfp-271