Rep 6.6.2 Developer Replacement - Xerox DocuColor 12/DCCS50 Service Manual

Figure 4 Remove the Development Housing
Installation
NOTE: If the Development Housing cannot be easily installed, the gears may not be meshed
properly. Rotate the gears clockwise slightly and then install the Development Housing.
1. Reinstall the parts in the reverse order of disassembly.
NOTE: If the developer material has been replaced, go to IQ47 ATC Sensor RAP,
ATC set-up procedure
Reissue
DocuColor 12/DCCS50

REP 6.6.2 Developer Replacement

Parts List on PL 6.6
Removal
Developer Removal
Turn power off and disconnect the power plug.
Do not put the Developer or Developer Unit into a fire. If the Developer or Developer Unit
is placed into a fire, it may explode and cause injury.
NOTE: After replacing the Development Housing, reset the HFSI counter. Enter the
HFSI Counter List Diag. Screen:
a. Yellow: location NVM 009-851
b. Magenta: location NVM 009-852
c. Cyan: location NVM 009-853
d. Black: location NVM 009-850
1. Remove the Development Housing
2. Place a sheet of paper on the floor or desk. Place the removed Development Housing on
it.
3. Remove the Upper Cover
1. Remove the screws (2).
2. Release the hooks (4) and remove the cover.
Appendix 1.
1/05
4-89
WARNING
WARNING
(REP 6.6.1).
(Figure 1).
Repairs and Adjustments
REP 6.6.1, REP 6.6.2
dC135