11-109 Oct Exit Sensor On Jam Short Rap - Xerox DocuColor 12/DCCS50 Service Manual

A B C
• Check the Drive Belt Tension Roll for proper tension.
• Check the Drive Belt for Damage
• Check that the gear pulleys are properly fastened to the drive rolls
Check the following parts for wear, glazing, or slipping.
• Entrance Roll (PL 13.9)
• Pinch Rollers (PL 13.9)
• Exit Roll (PL 13.9)
• Drive Belt (PL 13.10)
Check the Drive Belt Tension Roll for proper tension.
Check the OCT Exit Sensor Actuator for binding as it moves in and out of the sensor. The
actuator is binding.
Y N
Check for obvious damage, missing and/or broken Drive Motor gear assemblies and drive
belts that would cause the copy to be slow to actuate the OCT Exit Sensor.
Replace the OCT Exit Sensor (PL 13.9).
Reissue
DocuColor 12/DCCS50

11-109 OCT Exit Sensor On Jam Short RAP

The OCT Exit Sensor did not detect the lead edge of the paper within the specified time after
the Decurler Exit Sensor detected the trail edge of the same paper.
NOTE: If this machine has a Finisher/Sorter Accessory, go to Section 8D,
Sensor On Jam Short RAP to troubleshoot this Fault Code.
NOTE: "Short" indicates that the trail edge of the paper has passed through the Decurler Exit
Sensor.
Initial Actions
Refer to BSD11.2 and BSD 11.4 and BSD 11.8 for the following procedure.
Check for the following:
• Obstructions in the Mail Box paper path
• Bent or out of position paper chutes/guides in the Mail Box paper path
• Ensure that there is sufficient nip force at the Mail Box Transport Roll and the Oct Exit
Roll.
• Ensure that connectors P/J562
Exit Sensor are seated correctly and there are no obvious crimped or broken wires.
Procedure
The lead edge of the paper is at or past the Oct Exit Sensor
Y N
The paper entered the Vertical Transport.
Y N
Enter dC330 011-005 Mailbox Drive Motor. Press Start. The Mail Box Transport
Roll is rotating.
Y N
The Mail Box Drive Belt is moving.
Y N
The Mail Box Drive Motor is rotating
Y N
+24 VDC is measured between P/J572-1 and P/J572-2 of the
Mail Box Drive Motor
Y N
Go to
the wires are good, replace the Mail Box Control PWB
13.10).
Press Stop. +5 VDC is measured between P/J572-3 and GND.
Y N
Go to
the wire is good, replace the Mail Box Control PWB
Press Start. Less than +1 VDC is measured between P/J572-3
and GND.
Y N
Replace the Mail Box Control PWB
A B C D E F
1/05
11-108 OCT Exit Sensor Off Jam RAP, 11-109 OCT
2-187
11-109 SCT Exit
on the Mail Box Control PWB and P/J566
Flag 1on BSD11.2. Check the wires for an open circuit. If
Flag 3 on BSD 11.2. Check the wire for an open circuit. If
(PL 13.10)
Status Indicator RAPs
on the OCT
(PL
(PL 13.10).