Table of Contents
Advertisement
11-918 Bin 8 Full Stack RAP
The Control Logic detected that Bin 8 is full.
NOTE: If this machine has a Finisher/Sorter Accessory, go to Section 8D,
Stack RAP
to troubleshoot this Fault Code.
Initial Actions
•
Refer to BSD11.6 for the following procedure.
•
Ensure that Bin 8 is empty
Procedure
Enter dC330 011-288 Bin 8 Full Sensor. Press Start. Manually move the actuator in and out
of the sensor The display Changes from H to L to H as the actuator is moved in and out
of the sensor.
Y
N
Replace the Mail Box Control PWB
Check the Bin 8 Full Sensor for intermittent operation. If the problem continues, replace the
Mail Box Control PWB
(PL
13.10).
Reissue
DocuColor 12/DCCS50
11-918 Bin 8 Full
(PL
13.10).
11-919 Bin 9 Full Stack RAP
The Control Logic detected that Bin 9 is full.
NOTE: If this machine has a Finisher/Sorter Accessory, go to Section 8D,
Stack RAP
to troubleshoot this Fault Code.
Initial Actions
•
Refer to BSD11.6 for the following procedure.
•
Ensure that Bin 9 is empty
Procedure
Enter dC330 011-289 Bin 9 Full Sensor. Press Start. Manually move the actuator in and out
of the sensor The display Changes from H to L to H as the actuator is moved in and out
of the sensor.
Y
N
Replace the Mail Box Control PWB
Check the Bin 9 Full Sensor for intermittent operation. If the problem continues, replace the
Mail Box Control PWB
(PL
13.10).
1/05
11-918 Bin 8 Full Stack RAP, 11-919 Bin 9 Full Stack
2-211
11-919 Bin 9 Full
(PL
13.10).
Status Indicator RAPs
Advertisement
Table of Contents
Troubleshooting
