Table of Contents
Advertisement
3.
Select Start.
NOTE: If the Lead Edge Registration cannot be brought within specification, the NVM value for
the starting point may be out of range. Reset NVM location 761-048 to the default value of
1000 and perform the adjustment again.
4.
Repeat the check/adjustment until the specifications are met.
5.
Select Save [LR] to save the new NVM settings.
Duplex Side Edge:
1.
Use the Up and Down Arrow buttons to move the image toward or away from the outboard
edge of the paper. Each click on the button moves the image 0.0423 mm. The cumulative
amount of shift is indicated in the Side Reg. box.
2.
After adjusting the registration, click Set Adjust Value.
3.
Select Start.
NOTE: If the Side Edge Registration cannot be brought within specification, the NVM value for
the starting point may be out of range. Reset NVM location 720-008 to the default value of
7406 and perform the adjustment again.
4.
Repeat the check/adjustment until the specifications are met.
5.
Select Save [SR] to save the new NVM settings.
Repairs and Adjustments
ADJ 9.1.10
1/05
4-206
manuals4you.com
manuals4you.com
Reissue
DocuColor 12/DCCS50
Advertisement
Table of Contents
Troubleshooting
