Rep 8.3.4 Pressure Roll Heater Rod - Xerox DocuColor 12/DCCS50 Service Manual

NOTE: Install the spring as shown in the figure below
Figure 6 Install the Spring
After closing the Upper Frame Assembly, ensure that the two load springs are located correctly
at each end of the Donor Roll Assembly, The springs may become loose during service.
1. Reinstall the parts in the reverse order of disassembly.
2. Perform the Standard Fuser Break-In Procedure
3. Perform the Fuser Nip Adjustment
Reissue
DocuColor 12/DCCS50
(Figure 6).
CAUTION
(GP 1 Fuser Break-In Procedure).
(ADJ 8.1.1).

REP 8.3.4 Pressure Roll Heater Rod

Parts List on PL 8.3
Removal
Turn power off and disconnect the power plug.
Since the Fuser is very hot, wait until the Fuser becomes sufficiently cold.
Do not touch the glass surface of the Heater Rod. If the glass surface is accidentally touched,
wipe it with a dry cloth.
1. Open the Front Door.
2. Remove the Fuser Unit (REP
3. Remove the Front Cover (PL
4. Remove the bracket (Figure 1).
1. Disconnect the connector.
2. Release the clamp and remove the wire.
3. Remove the screw.
4. Remove the bracket.
Figure 1 Remove the Bracket (Front of Fuser)
1/05
4-125
WARNING
CAUTION
CAUTION
8.1.1).
8.1).
Repairs and Adjustments
REP 8.3.3, REP 8.3.4