Rep 7.1.2 Ibt Cleaner - Xerox DocuColor 12/DCCS50 Service Manual

REP 7.1.2 IBT Cleaner

Parts List on PL 7.1
Removal
NOTE: After replacing the IBT Cleaner, clear the HFSI counter. Enter
List Diag. Screen NVM 009-836.
Turn power off and disconnect the power plug.
Do not put the IBT Cleaner into a fire. If the IBT Cleaner is placed into a fire, it may
explode and cause injury.
NOTE: When removing the IBT, make sure that the IBT Belt does not touch any other part.
NOTE: Carefully place the removed IBT on a flat surface (covered with a sheet of paper).
NOTE: Place the removed IBT Cleaner on the floor, protected by a sheet of paper.
1. Open the Front Door.
2. Remove the IBT (REP 7.1.1).
3. Remove the IBT Cleaner (Figure 1).
1. Remove the screw.
2. Remove the IBT Cleaner.
Reissue
DocuColor 12/DCCS50
thedC135 HFSI Counter
WARNING
WARNING
Figure 1 Remove the IBT Cleaner
Installation
NOTE: Ensure that the inboard side of the IBT Cleaner is fully seated.
1. Reinstall the parts in the reverse order of disassembly.
1/05
4-101
Repairs and Adjustments
REP 7.1.2