Rep 7.6.2 Drive Roll - Xerox DocuColor 12/DCCS50 Service Manual

NOTE: Install the bearings at both sides of the Bias Roll in the positions shown in the figure
below (Figure 4).
Figure 4 Install the Bearings
1. Reinstall the parts in the reverse order of disassembly.
Repairs and Adjustments
REP 7.6.1, REP 7.6.2

REP 7.6.2 Drive Roll

Parts List on PL 7.6
Removal
Turn power off and disconnect the power plug.
NOTE: When removing the IBT, make sure that the IBT Belt does not touch any other part.
NOTE: Carefully place the removed IBT on a flat surface (covered with sheet of paper).
1. Remove the IBT Belt (REP
2. Remove the Drive Roll Cleaning Blade
1. Remove the Drive Roll Cleaning Blade.
Figure 1 Remove the Drive Roll Cleaning Blade
3. Remove the gear (Figure
1. Remove the screw.
2. Remove the gear.
1/05
4-106
manuals4you.com manuals4you.com
WARNING
7.5.1).
(Figure 1).
2).
DocuColor 12/DCCS50
Reissue