Figure 3 Adjusting the Gap
NOTE:
a.
Rotate once in the A direction, approximately 0.75mm lower.
b.
Rotate once in the B direction, approximately 0.75mm higher.
3.
Open the DADF and tighten the screws
1. Tighten the screws (2).
Repairs and Adjustments
ADJ 12.3.3
(Figure
4).
4.
Repeat the check steps and make sure that the height is correct.
1/05
4-220
manuals4you.com
manuals4you.com
Figure 4 Tightening the Screws
Reissue
DocuColor 12/DCCS50