Xerox DocuColor 12/DCCS50 Service Manual page 443

Figure 5 Remove the Heat Roll
10. Wipe off and then inspect the Heat Roll Thermistors (2) for wear or damage and replace
them as needed.
Reissue
DocuColor 12/DCCS50
Installation
NOTE: Ensure that the bearings are installed with the flanges toward the center of the roll so
that they fit inside the Fuser Frame (Figure 6).
Figure 6 Install the Heat Roll
NOTE: When installing the Heat Roll, press the stoppers down and lock the Heat Roll
7).
1. Press down the stoppers (2).
2. Tighten the screws (2).
1/05
4-119
(Figure
Repairs and Adjustments
REP 8.3.1