A
B
C
Y
N
Approximately +23 VDC is measured between P/J653-3, 4, 5, 6 and
GND.
Y
N
Replace the Decurler Control PWB
Replace the Decurler Stepping Motor
Check the following parts for wear, glazing, or slipping.
•
Entrance Roll
•
Pinch Rollers
•
Exit Roll
•
Drive gears
Go to the
10-111 Machine Exit Sensor Off Jam RAP
Check the following parts for wear, glazing, or slipping.
•
Entrance Roll
•
Pinch Rollers
•
Exit Roll
•
Drive gears
Ensure that the Decurler paper path is free of any paper. Enter dC330 011-145 Decurler Exit
Sensor. The display is L.
Y
N
+5 VDC is measured between P/J658-2 and GND.
Y
N
Go to
Flag 2
on BSD 11.3. Check the wire for a short circuit to ground. If the wire is
good, replace the Decurler Exit Sensor
Less than +0.5 VDC is measured between P/J570-B5 and GND.
Y
N
Go to
Flag 1
on BSD 11.3. Check the wire for an open circuit. If the wire is good,
replace the Decurler Control PWB
Replace the Mail Box Control PWB
(PL
Use a sheet of paper to actuate the Decurler Exit Sensor. The display changes to H.
Y
N
+5 VDC is measured between P/J656-1 and P/J661-3 on the Decurler Control PWB.
Y
N
CR1 on the Mail Box Control PWB is on.
Y
N
Go to the +5 VDC wirenet and troubleshoot the wires between P/J569-1 and
P/J44-6 on the Distribution PWB.
Replace the Mail Box Control PWB
Go to
Flag 3
on BSD 11.3. Check the wire for an open circuit. If the wires are good,
replace the Decurler Exit Sensor
(PL
F
Reissue
DocuColor 12/DCCS50
(PL
13.12).
(PL
13.14).
(PL
13.12).
(PL
13.12).
13.10).
(PL
13.10).
13.12).
F
More than +4.5 VDC is measured between P/J658-2 and GND.
Y
N
Replace the Decurler Exit Sensor
Check the following parts for wear, glazing, or slipping.
•
Entrance Roll
•
Pinch Rollers
•
Exit Roll
•
Drive gears
1/05
11-146 Decurler Exit Sensor On Jam Short RAP
2-199
(PL
13.12).
Status Indicator RAPs