Rep 1.3.1 Belt (Developer Drive) - Xerox DocuColor 12/DCCS50 Service Manual

REP 1.3.1 Belt (Developer Drive)

Parts List on PL 1.3
Removal
Turn power off and disconnect the power plug.
1. Remove the IOT Rear Cover (PL 11.3).
2. Remove the Toner Waste Bottle.
3. Open the IOT Control PWB Chassis
4. Remove the flywheel and flange (Figure
1. Remove the screws (2).
2. Remove the Flywheel.
3. Loosen the screws (2).
4. Remove the flange.
Figure 1 Removing the Flywheel
5. Remove the Waste Toner Auger (REP
6. Remove the Main Motor (Figure 2).
1. Disconnect the connectors (2).
2. Remove the screws (4).
Reissue
DocuColor 12/DCCS50
WARNING
(REP 9.2.1).
1).
5.5.1).
3. Remove the main motor.
Figure 2 Removing the Main Motor
7. Remove the Main Motor Bracket
1. Remove the screws (7).
2. Remove the bracket.
1/05
4-3
(Figure 3).
Repairs and Adjustments
REP 1.3.1