Xerox DocuColor 12/DCCS50 Service Manual page 447

Be careful when opening the Upper Frame Assembly; the load springs at each end of the
donor roll assembly may come off.
5. Open the Upper Frame Assembly (Figure
1. Remove the screws (2).
2. Open the Upper Frame Assembly.
Figure 2 Open the Upper Frame Assembly
NOTE: Before removing the Pressure Roll, observe the location of the flange on each
bearing. They should be inside the Lift Lever Frame (Figure 5).
6. Remove the Pressure Roll (Figure
1. Remove the Inlet Chute.
2. Remove the spring.
3. Remove the Pressure Roll.
Reissue
DocuColor 12/DCCS50
CAUTION
2).
3).
Figure 3 Remove the Pressure Roll
7. Wipe off, then inspect the Pressure Roll Thermistors (2) for wear or damage and replace
them as needed.
1/05
4-123
Repairs and Adjustments
REP 8.3.3