Rep 7.6.1 Bias Roll - Xerox DocuColor 12/DCCS50 Service Manual

Installation
NOTE: When installing the IBT Belt, make sure that the silver seal is towards the inboard side.
Also ensure that the Tracking Rings which are located on the inside of the IBT Belt, are not
riding on the ends of the Steering Roll or Drive Roll
Figure 5 install the IBT Belt
1. Reinstall the parts in the reverse order of disassembly.
Repairs and Adjustments
REP 7.5.1, REP 7.6.1
(Figure 5).
manuals4you.com manuals4you.com

REP 7.6.1 Bias Roll

Parts List on PL 7.6
Removal
Turn power off and disconnect the power plug.
NOTE: When removing the IBT, make sure that the IBT Belt does not touch any other part.
NOTE: Carefully place the removed IBT on a flat surface (covered with the sheet of paper).
1. Open the Front Door.
2. Remove the IBT Belt (REP 7.5.1).
3. Release the stoppers (Figure
1. Move the stoppers (2) in the direction of the arrow and release them.
Figure 1 Move the Stoppers
4. Remove the Bias Roll (Figure
1. Raise the Tension Roll.
2. Remove the Bias Roll.
1/05
4-104
WARNING
1).
2).
DocuColor 12/DCCS50
Reissue