Xerox DocuColor 12/DCCS50 Service Manual page 778

Table 2 v11.50.3 software
Location Value
700-191 1
700-193 0
700-099 1
710-062 0
710-063 0
720-794 62
730-027 260 (C/P only)
752-002 0 = no Foreign Interface
NOTE: When F/I is plugged in at
power-up, software will automati-
cally enable F/I (value=1).
752-004 0
752-012 0 = No Edit Pad
1 = Edit Pad Installed
752-017 1
759-004 0 = DC12 with DFE
1 = DCCS 50
Use default for DC12 w/o DFE
759-047 0
759-051 0
759-041 1
759-042 1
761-424 0
990-302 1
990-303 0
Table 3 v7.06.3 software
Location Value
710-062 0
710-063 0
752-002 0 = no Foreign Interface
NOTE: When F/I is plugged in at
power-up, software will automati-
cally enable F/I (value=1).
752-012 0 = No Edit Pad
1 = Edit Pad Installed
General Procedures
dC301 NVM Initialization
Table 3 v7.06.3 software
Location Value
759-004 0 = DC12 with DFE
1 = DCCS 50
Use default for DC12 w/o DFE
13. Go to dC371 Configuration Page. Verify the machine configuration. Correct any errors
before continuing.
14. Exit the Diagnostic Mode. To exit Diagnostic Mode, refer to
vice Mode.
15. Reconnect any Foreign Interface devices.
16. Run several copies/prints to confirm normal machine behavior.
17. Re-enter the Diagnostic Mode.
18. Set NVM location 715-001 to 0.
Set NVM location 720-368 to 0
19. Perform Max Setup (ADJ 9.1.1).
20. Exit the Diagnostic Mode.
1/05
6-98
manuals4you.com manuals4you.com
dC188 How to Exit from Ser-
Reissue
DocuColor 12/DCCS50