Table of Contents
Advertisement
GP 6 Verifying the Auditron Password
This procedure will enable the CSE to read a machine Auditron password if the SA has forgot-
ten their password or if the SA is unavailable.
Use this procedure only to read the password resident on the machine. Then use the pass-
word to access the Auditron Administrator Screen and change the password using the normal
procedure.
Procedure
1.
Enter the Service Diagnostics Mode, refer to:
using the PWS
2.
Select Adjustments in the Service Entry Screen.
3.
The system displays one of the Read/Write Screens. dC131 NVM Read/Write is the
default screen.
4.
Select Other from the Vertical Left Tab List.
5.
The system displays one of the Read/Write Screens. dC131 NVM Read/Write is the
default screen.
6.
Record and Retain NVM Values for the following locations:
•
850-001
•
850-002
•
850-003
•
850-004
•
850-005
•
850-006
•
850-007
Exiting from the Auditron Password
1.
Exit from dC131 NVM Read/Write Mode.
2.
Exit the Diagnostic Mode.
3.
Using the PWS, go to Programs/Accessories/Scientific Calculator (This is the stan-
dard accessory in Microsoft Windows)
a.
Calculator has two operating modes, select Scientific Format. To do this, on the
calculator icon, go to "View" and click Scientific.
b.
Make sure the "Decimal" and the "Deg" formats are selected.
c.
Enter decimal number.
4.
Convert the numbers recorded from the list above to hexadecimal (Select Dword on cal-
culator)
a.
Click the Hex format. This will leave you with a pair of two digit hex words.
5.
Convert the hexadecimal numbers to their ASCII code equivalent. Refer to
General Procedures
GP 6 Verifying the Auditron Password
CAUTION
Entering the Service Diagnostic Mode
Table
1.
1/05
6-8
manuals4you.com
manuals4you.com
Reissue
DocuColor 12/DCCS50
Advertisement
Table of Contents
Troubleshooting
