11-920 Bin 10 Full Stack Rap; 11-921 Offset Catch Tray Full Stack Rap - Xerox DocuColor 12/DCCS50 Service Manual

11-920 Bin 10 Full Stack RAP

The Control Logic detected that Bin 10 is full.
NOTE: If this machine has a Finisher/Sorter Accessory, go to Section 8D,
Stack RAP to troubleshoot this Fault Code.
Initial Actions
• Refer to BSD11.6 for the following procedure.
• Ensure that Bin 10 is empty
Procedure
Enter dC330 011-290 Bin 10 Full Sensor. Press Start. Manually move the actuator in and out
of the sensor The display Changes from H to L to H as the actuator is moved in and out
of the sensor.
Y N
Replace the Mail Box Control PWB
Check the Bin 10 Full Sensor for intermittent operation. If the problem continues, replace the
Mail Box Control PWB (PL 13.10).
Status Indicator RAPs
11-920 Bin 10 Full Stack RAP, 11-921 Offset Catch
11-920 Bin 10 Full
(PL 13.10).

11-921 Offset Catch Tray Full Stack RAP

The Control Logic detected that the Offset Catch Tray is full.
NOTE: If this machine has a Finisher/Sorter Accessory, go to Section 8D,
Full Stack RAP to troubleshoot this Fault Code.
Initial Actions
• Refer to BSD11.7 for the following procedure.
• Ensure that the Offset Catch Tray is empty
• Ensure that connectors
Double Plug J880, and
are no obvious crimped or broken wires.
Procedure
Enter dC330 011-275 Full Stack Sensor. Press Start. The display is H.
Y N
+5 VDC is measured between P/J564-5 and DC-COM on the Mail Box PWB.
Y N
Go to Flag 1 on BSD11.7. Check the wire for a short circuit to ground. If the wire is
good, replace the Full Stack Sensor
Replace the Mail Box Control PWB
Block the Full Stack Sensor with a sheet of paper. The display changes to L.
Y N
+5 VDC is measured between
Y N
CR1 on the Mail Box Control PWB is on.
Y N
Go to the +5 VDC wirenet and troubleshoot the wires between P/J569-1 and
P/J44-6 on the Distribution PWB.
Replace the Mail Box Control PWB
Go to Flag 1 and Flag 2
ness is good, replace the Full Stack Sensor
the Full Stack Sensor for intermittent operation, If the problem continues, replace the Full Stack
Sensor (PL 14.1).
1/05
2-212
manuals4you.com manuals4you.com
P/J564 on the Mail Box Control PWB, Shorting Plug P/J801A,
P/J807 on the Full Stack Sensor are seated correctly and there
(PL 14.1).
(PL 13.10).
P/J564 -4 and P/J564-3 on the Mail Box PWB.
(PL 13.10).
on BSD 11.7. Check the harness for an open circuit. If the har-
(PL 14.1).
DocuColor 12/DCCS50
11-921 SCT Tray
Reissue