Rep 8.3.2 Heat Roll Heater Rod - Xerox DocuColor 12/DCCS50 Service Manual

Figure 7 Lock the Heat Roll
After closing the Upper Frame Assembly, ensure that the two load springs are located correctly
at each end of the Donor Roll Assembly, The springs may become loose during service.
1. Reinstall the parts in the reverse order of disassembly.
2. Perform the Standard Fuser Break-In Procedure
3. Perform the Fuser Nip Adjustment
Repairs and Adjustments
REP 8.3.1, REP 8.3.2
CAUTION
(GP 1 Fuser Break-In Procedure).
(ADJ 8.1.1).

REP 8.3.2 Heat Roll Heater Rod

Parts List on PL 8.3
Removal
Turn power off and disconnect the power plug.
Since the Fuser is very hot, wait until the Fuser becomes sufficiently cold.
Do not touch the glass surface of the Heater Rod. If the glass surface is accidentally touched,
wipe it with a dry cloth.
1. Open the Front Door.
2. Remove the Fuser Unit (REP
3. Remove the Front Cover
4. Remove the bracket (Figure
1. Release the clamp and remove the wire.
2. Remove the wire from the saddle edge.
3. Disconnect the connector.
4. Remove the screw.
5. Remove the bracket.
1/05
4-120
manuals4you.com manuals4you.com
WARNING
CAUTION
CAUTION
8.1.1).
(PL 8.1).
1).
DocuColor 12/DCCS50
Reissue