8-152 Takeaway Sensor On Rap - Xerox DocuColor 12/DCCS50 Service Manual

A B
Press the Start button. The voltage at P/J802B-9 goes to approximately 0 VDC.
Y N
There is +5 VDC between P/J801B-6 on the Tray PWB and GND.
Y N
Flag 6 on BSD 8.4 and check the harness for an open circuit. If the har-
Go to
ness is good, replace the IOT Drive PWB
Replace the Tray PWB (PL 9.3).
Replace the Tray 4 Takeaway Feed Clutch
Check/replace the following components until the problem is resolved. Replace any compo-
nents that are worn, broken, binding, or slipping.
• Pinch Rolls and Springs (PL 2.8)
• Check for burrs on the Baffle (PL 2.8)
• Gears in the Takeaway Drive Assembly
Status Indicator RAPs
8-150 Tray 4 Takeaway Sensor On Jam RAP, 8-152
(PL 2.7A).
(PL 2.7A)

8-152 Takeaway Sensor On RAP

The Takeaway Sensor detected paper when closing the Front Cover or when power was
switched on.
Initial Actions
• Refer to BSD 8.6 and BSD 8.10 for the following procedure.
• Check for any obstructions in the paper path.
• Open the Lower Left Door
Procedure
Cheat the L/H Cover Interlock Switch. Enter dC330 008-150 Take Away Sensor. Press the
Start button. The display indicates H.
Y N
Go to Flag 1 on BSD 8.6 and check the harness for a short circuit. If the harness is OK,
replace the Takeaway Sensor
If the fault code is present and can not be cleared, replace the IOT Drive PWB
fault code is not present and is occurring intermittently, go to
harness for an intermittent short circuit. If the harness is OK, replace the Takeaway Sensor
2.8). If the problem continues, replace the IOT Drive PWB
1/05
2-96
manuals4you.com manuals4you.com
(PL 2.8).
(PL 2.8).
Flag 1 on BSD 8.6 and check the
(PL 9.2).
DocuColor 12/DCCS50
(PL 9.2). If the
(PL
Reissue