Rep 8.8.2 External Heat Roll - Xerox DocuColor 12/DCCS50 Service Manual

REP 8.8.2 External Heat Roll

Parts List on PL 8.8
Removal
NOTE: After replacing the External Heat Roll, Enter
counter 010-803.
Turn power off and disconnect the power plug.
Since the Fuser is very hot, Wait until the Fuser becomes sufficiently cold.
Do not touch the glass surface of the Heater Rod. If the glass surface is accidentally touched,
wipe it with a dry cloth.
1. Open the front door.
2. Remove the External H/R Heater Rod
3. Remove the External Heat Roll (Figure 1
1. Remove the rings (2).
2. Remove the bearings (2).
3. Remove the External Heat Roll.
4. Clean and inspect the two External Heat Roll Thermistors.
Repairs and Adjustments
REP 8.8.2
dC135 HFSI Counter List and reset HFSI
WARNING
CAUTION
CAUTION
(REP 8.8.1).
).
Figure 1 Remove the External Heat Roll
Installation
1. Reinstall the parts in the reverse order of disassembly.
2. Perform the Standard Fuser Break-In Procedure
3. Adjust the External Heat Roll Nip
1/05
4-136
manuals4you.com manuals4you.com
(GP 1 Fuser Break-In Procedure).
(ADJ 8.8.1).
DocuColor 12/DCCS50
Reissue