3-311 IOT-SYS Logic Fail RAP
The IOT-SYS Software Logic Failure was detected after a certain time period (the NVM value).
Initial Actions
•
Refer to BSD 3.12 Monitoring in this procedure:
Procedure
Perform the following:
•
PO/PO the machine
•
Reset the connectors on the IOT CPU PWB
•
Replace the IOT CPU PWB
(PL
9.2)
Reissue
DocuColor 12/DCCS50
(PL
9.2)
3-315 IOT/IPS Communications Fail RAP
The 3-315 Fault Code indicates that a communication failure between the IOT PWB and the
Post IPS PWB was detected.
Initial Actions
•
Ensure that
P571
is firmly connected to the Post IPS PWB.
•
Refer to BSD 3.2 PWB Communications (IPS) and BSD 3.12 Monitoring in this proce-
dure:
Procedure
There is +3.5 VDC from J 570 pin 1 to pin 6 on the Post IPS PWB.
Y
N
Go to
Flag 5
on BSD 3.2. Check for an open or a short circuit to GND. If the wires are OK,
replace the IIT LVPS
(PL
3.5).
There is +3.5 VDC from J 517 pin 3 to pin 4 on the Pre IPS PWB.
Y
N
Go to
Flag 6
on BSD 3.2. Check for an open or a short circuit to GND. If the wires are OK,
replace the IIT LVPS
(PL
3.5).
There is +5 VDC from J 517 pin 1 to pin 2 on the Pre IPS PWB.
Y
N
Go to
Flag 6
on BSD 3.2. Check for an open or a short circuit to GND. If the wires are OK,
replace the IIT LVPS
(PL
3.5).
There is +13.3 VDC from J 517 pin 7 to pin 5 on the Pre IPS PWB.
Y
N
Go to
Flag 6
on BSD 3.2. Check for an open or a short circuit to GND. If the wires are OK,
replace the IIT LVPS
(PL
3.5).
Perform the following:
•
PO/PO the machine
•
Go to
Flag 3
and
Flag 4
on BSD 3.2. Check the following wires for a short/open circuit:
–
Between Post IPS PWB P571-23 and IOT CPU PWB P/J404-A13
–
Between Post IPS PWB P571-24 and IOT CPU PWB P/J404-A14
–
Between Post IPS PWB P571-25 and IOT CPU PWB P/J404-A11
–
Between Post IPS PWB P571-26 and IOT CPU PWB P/J404-A12
•
Replace the PRE IPS PWB
(PL
•
Replace the IOT CPU PWB
(PL
•
Replace the Post IPS PWB
(PL
•
Replace the MEM SYS PWB
(PL
1/05
3-311 IOT-SYS Logic Fail RAP, 3-315 IOT/IPS Com-
2-15
3.5)
9.2)
3.5)
3.5)
Status Indicator RAPs