Rep 8.3.5 Heat Roll Stripper Finger - Xerox DocuColor 12/DCCS50 Service Manual

REP 8.3.5 Heat Roll Stripper Finger

Parts List on PL 8.3
Removal
Turn power off and disconnect the power plug.
Since the Fuser is very hot, wait until the Fuser becomes sufficiently cold.
1. Open the Front Door.
2. Remove the Fuser Unit (REP 8.1.1).
3. Remove the Heat Roll Stripper Finger Assembly
NOTE: Do not damage the Stripper finger tips.
1. Raise the Exit Chute.
2. Loosen the screw.
3. Remove the screw.
4. Remove the Heat Roll Stripper Finger Assembly.
Figure 1 Remove the Heat Roll Stripper Finger Assembly
4. Remove the Heat Roll Stripper Finger
1. Remove the spring tip from the groove.
2. Remove the stud.
Reissue
DocuColor 12/DCCS50
WARNING
CAUTION
(Figure 1).
(Figure 2).
3. Remove the spring.
4. Remove the Heat Roll Stripper Finger.
Figure 2 Remove the Heat Roll Stripper Finger
Installation
1. Install the Heat Roll Stripper Finger
1/05
4-127
(Figure 3).
Repairs and Adjustments
REP 8.3.5