Adj 9.1.3 Adc Agc Setup (Dc934); Adj 9.1.4 Vh/Vm Setup (Dc933) - Xerox DocuColor 12/DCCS50 Service Manual

ADJ 9.1.3 ADC AGC Setup (dC934)

Purpose
To adjust the ADC gain to obtain the specified Vclean and to measure the Vclean non-unifor-
mity on the belt.
Adjustment
1. Enter the PWS Diag.Screen for dC934.
2. Select Start.
3. If OK's are displayed in the Set Value Judgement column, proceed to Step 5 below.
4. If an NG is displayed, check the lower left corner of the screen for Faults. Correct the
faults and repeat the adjustment.
5. Perform (ADJ 9.1.4) VH/VM Setup
Repairs and Adjustments
ADJ 9.1.3, ADJ 9.1.4
(dC933 VH/VM Setup).

ADJ 9.1.4 VH/VM Setup (dC933)

Purpose
To set the output values of the VG, LD light amount, development bias, and ASG bias.
Adjustment
1. Enter the PWS Diag.Screen for dC933.
2. Select Start.
3. If OK's are displayed in the Judgement column, proceed to step 5.
4. If an NG is displayed, check the lower left corner of the screen for faults. Correct the
faults and repeat the adjustment.
5. Perform (ADJ 9.1.5) IOT Highlight Setup
1/05
4-200
manuals4you.com manuals4you.com
(dC918 IOT Highlight Setup).
Reissue
DocuColor 12/DCCS50