Load Media Into The Paper Module - Oce VarioPrint i Series Operation Manual

Load media into the paper module

Load media into the paper module
Media must be loaded in optimal condition and according to load instructions.
A job also needs media to print nozzle failure detection sheets. These media can be job media, or
alternative media if the job media are not appropriate for nozzle failure detection sheets. These
alternative media are loaded in the paper tray configured for that purpose. (
quality control sheets on page
[106] Location of the paper module (front view)
NOTE
• You can leave the media in the paper trays when the printer is in sleep mode. (
sleep mode on page
• Rewrap all loaded media in the original package or other moisture proof material before the
printer goes in shutdown mode. (
Before you begin
• Carefully unpack and check one ream of media or a stack of approximately 500 sheets (80 g/
m² / 20 lb bond). (
• Load media as soon as possible after unpacking.
• When you load media with a small length (178 mm - 203 mm / 7.01" - 7.99") the paper tray
needs a guidance tool.
[107] Guidance tool
94 Chapter 6 - Job media handling
243)
324)
Put printer in sleep mode on page
Unpack the media on page
92)
Define usage of
Put printer in
324)