Loading The Media Into The Printer - Oce CS9090 User Manual

Lock one roll unit to the roll unit bar
Step 4 :
Place one side of the roll over the flange of the locked unit.
Step 5 :
Slide the flange of the other roll unit into the roll and lock the unit by using its handle.
Step 6 :
You can now de-lock both sides to do adjustment of the position of the roll. The middle of the roll
Step 7 :
has to correspond to the middle of the printing space. After adjustment, lock both roll units again.
Notes
We recommend wearing cotton gloves to avoid fingerprints on the inkjet media.
4.6.2.2

Loading the media into the printer

P 1 : I
ART NSTALLING AN EMPTY CORE AND LOADING THE MEDIA THROUGH THE REAR TENSIONING
SYSTEM
Make sure the printer and UW/W 100 are ON.
Step 1 :
Press the [F4] key to raise the pressure rollers.
Step 2 :
Open the front cover.
Step 3 :
Install an empty core between the motorized roll unit and roll unit of the winder unit on front of the
Step 4 :
printer.
Notes
Make sure the core is longer than the media width.
Make sure both unwinder (REAR) and winder (FRONT) unit are set to MANUAL mode.
Step 5 :
Use the foot-switch to release some media on the rear.
Step 6 :
Load media through the rear tensioning system as shown below.
Step 7 :
Printable side on the outside of the roll
AP-75036 - Revision 1.3 – 20/03/06
1 = Unwinder
2 = Rear tensioning system
3 = Media insertion slot of the printer
Printable side on the inside of the roll
55
Chapter 4: Preparing for a job
User's Guide CS9000 series