Connecting The Cables; Connecting The Foot Switch - Oce CS9265 Installation Manual

5.1 CONNECTING THE FOOT SWITCH

If the pressure rollers need to be raised or lowered, it is possible to do this by way of the foot switch, instead
of doing so at the operation panel.
Caution
•
W
HEN HANDLING THE FOOT SWITCH
D
O NOT PLACE ANYTHING HEAVY ON THE FOOT SWITCH
o
D
O NOT BEND THE CABLE OF THE FOOT SWITCH WITH FORCE AND DO NOT PULL
o
D
O NOT PLACE THE FOOT SWITCH NEAR THERMAL DEVICES
o
Install the foot switch according to following procedure:
Step 1 : Make sure that the power of the unit is OFF.
Step 2 : Connect the foot switch cable connector to the foot switch connector at the rear of the unit and fix
it with the pre-installed screw.
Step 3 : Place the foot switch on the floor under the stand.

5 CONNECTING THE CABLES

,
BE AWARE OF THE FOLLOWING
33
CS9200 Low Solvent series printers
:
.
.
.
AP-40301 – Rev. 2.0 – 02/05/2008