Connecting The Foot Switch - Oce CS9090 User Manual

Chapter 4: Preparing for a job

4.3 CONNECTING THE FOOT SWITCH

The connection procedure for the foot switch is described below.
If the pressure roller needs to be raised or lowered, it is possible to control this motion from the foot switch,
instead of doing so at the operation panel.
Caution
•
When handling the foot switch, be aware of the following:
Do not place anything heavy on the foot switch.
o
Do not bend the cable of the foot switch with force and do not pull.
o
Do not place the foot switch near thermal devices.
o
Install the foot switch according to following procedure.
Make sure that the power of the unit is OFF.
Step 1 :
Notes
When the printer is ON, the power LED is lid green. Push the power button again to turn off the machine.
Connect the foot switch cable connector to the foot switch connector at the rear of the unit and fix
Step 2 :
into place with a screw.
Place the foot switch (1) on the floor under the stand.
Step 3 :
AP-75036 - Revision 1.3 – 20/03/06
Foot switch connector
1
Foot switch cable
2
44 User's Guide CS9000 series