Replacing The Waste Liquid Tank - Oce CS9090 User Manual

7.4.3 Replacing the waste liquid tank

Read following information on when and how to replace the waste liquid tank.
(1) Replacement Time
Replace the waste liquid tank under the following conditions.
a. When the waste liquid tank is nearly full.
•
Following message is displayed on the operation panel.
•
Printing continues.
•
Prepare a new waste liquid tank before the waste liquid tank becomes full.
(2) Replacement Procedures
Follow the steps below to replace the waste liquid tank.
Check the following if the power of the printer is ON.
Step 1 :
Printer is not printing.
I)
II) Operation panel is in normal status.
III) Media setting light on the operation panel is off.
Follow "Menu setup on the operation panel" and display the tank replacement menu on the
Step 2 :
operation panel. (Refer to 'Tank change menu')
Open the cap of the waste liquid tank.
Step 3 :
Caution
Do not bend or pull the waste fluid tube. Doing so may cause that the waste fluid will leak out and
malfunction in the product.
Remove the waste liquid tank from the tank tray of the stand.
Step 4 :
Notes
Put the used waste liquid tank in a plastic bag and follow the local regulations when disposing.
AP-75036 - Revision 1.3 – 20/03/06 165
Chapter 7: Maintenance
User's Guide CS9000 series