Transport Material To Accumulator; Setting The Accumulator Side Guides - Pitney Bowes F65A Operator's Manual

Transport material to accumulator

Turn the Accumulator Side Guide adjustment wheel anticlockwise to open the accumulator
side guides as wide as needed. Load one piece of material and press Run /confirm (green)
until it is fed into the accumulator.
The display shows the message:
4. Transport material to Accumulator
GREEN=Transport

Setting the accumulator side guides

With the paper in the accumulator you can adjust the side guides and leave gap of 2-3 mm
on each side. The display shows:
5. Accumulator side guide adjustment
GREEN=CONFIRM
Rotate the Accumulator Side Guide adjustment wheel clockwise to set the Accumulator
Side Guides. The correct setting allows approximately 3mm overall clearance so that the
material is controlled but not restricted by the guides
BLUE=EXIT
BLUE=EXIT
19