Chapter 9
Refilling the Tape Sealant Bottle
Refill the tape sealant bottle when your E-Z Seal® Sealing Solution is running low.
NOTE: Pitney Bowes recommends using E-Z Seal® Sealing Solution because it helps
keep your moistener tank clean and improves sealing performance.
1. Lift the tape sealant bottle out of the cradle. The bottle is located to the right of the printer
module, behind the stacker.
2. Remove the cap from the bottle.
3. Add enough E-Z Seal® to bring the level up to the bottom of the throat of the bottle. Do
not overfill the envelope sealant bottle.
4. Replace and tighten the cap and return the bottle to its original position.
Moistener Maintenance
You can clean the part of your mailing system that moistens the flap on the envelope. This
part of the mailing system is the moistener pad assembly. If the seal quality does not improve
after cleaning, you can replace the wick or moistener pad assembly as needed.
Cleaning or Replacing the Moistener Pad Assembly
We suggest that you clean the moistener pad assembly from time to time to remove residue
from the moistener pad. If wear of the moistener pad is affecting seal quality, you can replace
the moistener pad assembly.
183
SV62250 Rev. G