Subaru 2009 IMPREZA Service Manual page 2814

Hide thumbs Also See for 2009 IMPREZA:

2. DISPLAY OF STATUS INFORMATION

Check the operating condition of each sensor in the event of malfunction in the seat belt buckle switch, or

when the seat belt buckle switch has been replaced.

1) On «Main Menu» display, select {Each System Check}.

2) On «System Selection Menu» display, select {Airbag System}.

3) On «Airbag System» display, select {Status Data}.

The following table is for support data.

Seat position sensor LH

Seat position sensor RH

Seat belt buckle switch LH

Seat belt buckle switch RH

Passenger's airbag control status

*1: The seat position is forward.

*2: The seat position is rearward.

*3: Displayed when data other than before and behind the seat, such as the breakdown etc, is input.

*4: Displayed when it is initial.

*5: Seat position sensor not supported

*6: Seat belt fastened

*7: Seat belt not fastened

*8: Displayed when data other than belt fastened or not fastened, such as breakdowns is input.

*9: Seat belt buckle switch not supported

*10: Passenger's airbag operating state

*11: Passenger's airbag non-operating state

For details concerning the operation procedure, refer to "PC application help for Subaru Select Monitor".

3. CLEAR MEMORY MODE

Clear the DTC stored in the airbag control module after repairing the airbag system. (After the breakdown is

recovered, the breakdown code for completed recoveries are read out when the next breakdown occurs if the

memory clear work is not performed.)

1) On «Main Menu» display, select {Each System Check}.

2) On «System Selection Menu» display, select {Airbag System}.

3) Select the {Clearing Memory} in «Airbag System».

4) When the "Clear Memory?" is shown on the screen, select [OK].

5) When "Done" is displayed, end the Subaru Select Monitor.

For details concerning the operation procedure, refer to "PC application help for Subaru Select Monitor".

Subaru Select Monitor

/ Initial Setting

AIRBAG SYSTEM (DIAGNOSTICS)

/ Initial Setting