NEC Univerge SV8100 Features And Specifications Manual page 820

Issue 7.0
Calling Party Name

If programmed, Calling Party Name allows the station name to be sent out over the ISDN network.
A system wide name can be programmed to be sent over the network or the name can be defined
on a per station basis. If both are programmed, the system wide name takes priority over the
station name.
SMDR Includes Dialed Number

The SMDR report can optionally print the trunk name (entered in system programming) or the
number the incoming caller dialed (i.e., the dialed ISDN digits). This allows you to analyze the
SMDR report based on the number your callers dial. (This option also applies to a DID trunk.)
Display Shows Why Caller ID is Not Available

With Caller ID enabled, the system provides information for ISDN calls that do not contain the
Caller ID information. If the Caller ID information is restricted, the telephone display shows
PRIVATE. If the system cannot provide Caller ID information because the Telco information is not
available, the display shows OUT OF AREA.
Conditions
Primary Rate Interface (PRI):

The system is compatible with ISDN Primary Rate Interface (PRI) services. PRI services
currently supported include:
Basic PRI Call Control (BCC)

Display of incoming caller's name and number when allowed by Telco

Routing in the system based on the number the caller dialed

ISDN maintenance functions (such as In Service/Out of Service Messaging)

Speech and 3.1 KHz audio

PRI ability requires the installation of CD-PRTA. Each PRI circuit provides 24 PRI channels
(23B + D) 4 with 64K Clear Channel response. The T1/PRI Interface uses a single slot.
When installed, the T1/PRI Interface uses the first block of 24 consecutive trunks. For
example, if you have an
automatically uses trunks 9~32. If you have
and 17~24, the T1/PRI uses trunks 25~48. The T1/PRI Interface cannot use trunks 9~16
(even if available) since they are not part of a consecutive block of 24 trunks.
The sending of Calling Party Name display information to the public network with ISDN PRI

is only supported with NI2 protocol.
When using Mobile Extension in a NetLink Network, the ISDN/PRI must be utilized in the

Primary System.
When using fractional PRI, the blade comes up as zero ports until Program 10-03-06 is set

to the 4/8/12/16/20/24(auto), and then reset.
2 - 792
installed for trunks 1~8, the T1/PRI Interface
CD-4COT + PZ-4COT
CD-4COT + PZ-4COT
UNIVERGE SV8100
installed for trunks 1~8
ISDN Compatibility