Table 2-36 Restrictions For Calling Party Names - NEC Univerge SV8100 Features And Specifications Manual

Hide thumbs Also See for Univerge SV8100:

Features and specifications manual (2210 pages)

Features & specifications manual (1174 pages)

Programming manual (986 pages)

Table of Contents

UNIVERGE SV8100

If fractional PRI has the number of ports changed, the Trunk Port number might change if

they become split or fit into an empty gap of trunk ports. For example, if you have a

CD-4COT + PZ-4COT

as 25~36 and the PRI is changed to be eight ports instead of 12 ports, the new trunk port

numbers would be 9~16 because the eight ports can now fix into the gap without being split

ports. Another example, if you have a

and the PRI (8 ports) was assigned as 9~16 and then you change the PRI to be 12 ports

instead of eight, the new trunk ports would be 25~36 because the ports have to be split to

keep the original port numbers, and this is not supported.

If using a CSU/DSU, Program 10-03-13 must be set to 0. If not using a CSU/DSU,

Program 10-03-13 must be set to 1~7 or anything other than 0.

Restrictions for Calling Party Name:

The UNIVERGE SV8100 supports receiving the name from the Network in supported

formats only and cannot send the Calling Name. Refer to

Calling Party

4ESS (AT&T Custom)

AT&T5ESS Lucent Custom

DMS-100 (Custom)

DMS-100 (National; ISDN)

Nortel Specification NIX-A211-1

CO Line Service is not supported

ISDN – PRI cannot be configured for CO Emulation

B-Channel to Trunk Association

When an Incoming ISDN-BRI/PRI call is received, the system assigns the lowest trunk

number of the ISDN circuit to the incoming call associated with the B-Channel. When an

Outgoing call is placed using the ISDN-PRI/BRI, the system assigns the Trunk and

B-Channel association according to the chart below. This is based on the Trunk-to-Trunk

Group and Trunk Group Priority assignment in (Program 14-05-01).

ISDN Compatibility

for Trunks ports 1~8 and 17~24 and the PRI (12 ports) was assigned