NEC Univerge SV8100 Features And Specifications Manual page 740

Issue 7.0
Program
Program Name
Number
20-18-01 Service Tone Timers – Extension
Dial Tone Time
21-01-02 System Options for Outgoing
Calls – Intercom Interdigit Time
82-01-01 Incoming Ring Tone –
(01) Frequency 1
82-01-02 Incoming Ring Tone –
Frequency 2
82-01-03 Incoming Ring Tone –
Modulation
Handsfree Answerback/Forced Intercom Ringing:
Program
Program Name
Number
20-02-12 System Options for Multiline
Telephones – Forced Intercom
Ring (ICM Call Type)
20-06-01 Class of Service for Extensions
2 - 712
Description/Comments
After getting Intercom dial tone, a
multiline terminal user has this
time to dial the first digit of the
Intercom call.
When placing Intercom calls, an
extension user must dial each digit
during this time.
Customize the Intercom ring tone.
Customize the Intercom ring tone.
Customize the Intercom Ring
Tone modulation if desired.
Description/Comments
Enable/Disable Forced Intercom
Ringing. If enabled, Intercom calls
normally ring. If disabled,
intercom calls voice announce.
For all NEC Cordless telephones,
this option must be enabled since
voice announce is not possible.
Assign Class of Service (1~15) for
extensions.
UNIVERGE SV8100
Assigned Data
1
0~64800 (seconds)
(default = 30)
0~64800 (seconds)
(default = 10)
1 = 520Hz
2 = 540Hz
3 = 660Hz
4 = 760Hz
5 = 1100Hz
6 = 1400Hz
7 = 2000Hz
Default:
Refer to Table 2-31
Default Incoming
Ringing Tone on page
2-714.
0 = No Modulation
1 = 8Hz Modulation
2 = 16Hz Modulation
3 = Envelope
(default = 2)
Assigned Data
1
0 = Disable (Voice)
1 = Enable (Signal)
(default = 0)
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:

Extension port 101 =
Class 15
All other extension port
= Class 1
Level
2 3





Level
2 3

Intercom