NEC Univerge SV8100 Features And Specifications Manual page 849

Hide thumbs Also See for Univerge SV8100:
Table of Contents

Advertisement

UNIVERGE SV8100
SV8100 K-CCIS-IP to another SV8100, for calls from an IP terminal to a TDM terminal/
trunk via Peer-to-Peer, the IP Terminal's Codec must match the CCIS Codec and the
packet size is auto negotiated based on the receiving sides packet size.
SV8100 K-CCIS-IP to another SV8100 or to a NEAX PBX (SV8300, SV8500, etc.), for calls
from an IP terminal to another IP terminal/trunk via Peer-to-Peer, the IP Terminal's Codec
must match and the packet size is auto negotiated.
SV8100 K-CCIS-IP to a NEAX PBX (SV8300, SV8500, etc.), for calls from an IP terminal to
a TDM terminal via Peer-to-Peer, the IP Terminal's Codec and packet size (Program
84-24-XX) need to match the NEAX PBX CCIS Codec and packet size settings.
Related Features
K-CCIS – IP
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Program Name
Number
10-26-04
IP System Operation Setup –
DT700 Peer to Peer Mode
50-15-04
CCIS over IP Basic Information
Setting – Connection Method for
Terminal
84-21-21
CCIS over IP CODEC Information
Basic Setup – DTMF Relay Mode
K-CCIS – IP
Description/Comments
Use to Enable (1) or Disable (0)
the Peer to Peer feature for SIP
MLT and SIP IP stations.
Choose the connection method for
the DT700.
When connecting to a SV8300 or
SV8500 this must be set to 2
(H.245).
Assigned Data
1
0 = Off
1 = On
(default = 1)
0 = Peer-to-Peer
disable
1 = Peer-to-Peer
enable
(default = 1)
0 = Disable
2 = Inbound(RFC2833
3 = Outbound(H.245)
(default = 0)
Issue 7.0
Level
2
3
2 - 821

Advertisement

Table of Contents
loading

Table of Contents