Table of Contents
Advertisement
Installation Procedures
INSTALLATION OF NETWORK INTERFACE BOARD
The standard interface for the Rockhopper printer has a parallel Centronics compatible
interface as standard equipment. The network interface board, RJ-ETH14TX, for
connection to EtherNet is also available as an option.
The following procedure explains how to install the network interface board.
To install the network card proceed as follows:
Step 1 :
Loosen the two screws, which are fixed to
the interface cover plate on the left side of
the Board box below the printer and remove
the plate.
Step 2 :
Insert the optional interface board into the
slot as shown in the diagram. When the
interface board has reached the back, push
it again to ensure it is pushed fully back.
Step 3 :
Fasten the two interface mounting screws.
Caution:
• When installing the Network interface board, make sure that the
Rockhopper printer is switched off and the power cable is
disconnected.
Caution:
• Electronic components are susceptible to damage by static
electricity. Remove static charge from your clothes and body by
touching your hands to the board box before you touch the network
interface board.
Operation Instructions Rockhopper Printer
1. Interface cover plate
2. Board box
1. Interface board
31
Page
AP-75024 Rev. 1.2. – 18/08/2002
Advertisement
Table of Contents
