Product Overview; Part Names And Functions; Front - MUTOH Spitfire 100 Extreme Operation Instructions Manual

2.1 PART NAMES AND FUNCTIONS

2.1.1 Front

No Name
1
Maintenance Area
2
Paper Guide
3 Front cover
4
TL light switch
5
Operation panel
SmartChip Management
6
System
7
Ink compartment
8
LED indicators
9
Waste bottle
10 Stand
11
Unwinder/Winder PCB Box
12
Winder system
Unwinder/Winder control
13
panel
14 Front swingbar
Spitfire 100 Extreme series printers – Operation Instructions

2 PRODUCT OVERVIEW

Function
To perform a part of the daily and weekly maintenance. For example cleaning around
the heads.
A mirror has been installed to optimize sight.
Support the media during printing.
This cover keeps the operator safe from the drive parts of the printer while it is
operating. Only open and or close the cover to perform following operations.
•
Media set and replacement
•
Cutter blade replacement
•
Cleaning the wipers and other maintenance
•
In case of media jams
To light up the TL lights (blue and white)
This panel is used to set operational conditions, the status of the printer and other
functions.
To control the ink volume on your printer
Sixteen slots available to install ink cassettes.
Indicates if there is a cassette in the slot below the LED and if it is empty or not.
To collect the waste fluid. Should be emptied according to the procedure described in
this manual.
This stand is used to install the printer on a flat surface floor.
This box contains all electronics to control the unwinder winder 100 system.
Motorized roll-up system.
To control the complete unwinder/winder 100 system.
To adjust the tension of the media and to optimize the winding of the media.
11
CHAPTER 2: PRODUCT OVERVIEW
AP-77200, Rev. 1.1, 05/07/07