Part Names And Functions; Front - MUTOH DT-Series Operation Instructions Manual

2.4. PART NAMES AND FUNCTIONS

Part names and functions are explained below.

2.4.1. Front

No. Name
1 Operation panel
2 Ink compartment
3 Front cover
4 Pressure rollers
5 Maintenance cover
6 Stand
7 Media cut groove
8 Foot switch
9 Paper Guide
10 ETT
Mutoh's DT-Series Printers – Operation Instructions
Function
This panel is used to set operational conditions, the status of the
printer, and other functions.
This is the place for installing ink cassettes.
This cover keeps the operator safe from the drive parts of the printer
while it is operating. Only open and/or close the cover to perform
following operations:
Media setting and replacement
Cutter blade replacement
Cleaning the cleaning wiper
In case of media jam.
This roller is used to press the media from above and keep it flat when
printing.
This protects users from electric shocks caused by touching the
internal electrical parts. The cover is opened when expansion memory
(optional) has to be installed, and is closed for normal use.
This stand is used to install the printer on a surface flat floor.
Standard with the unit is the unwinder / winder 100 system. This
system should be mounted onto the stand.
Used to cut the media straight when it is cut manually.
This switch is used to raise and lower the pressure rollers.
Support the media during printing
It houses post-heater (dryer).
The ETT Extra Tension Tool pulls the media in line with the print
platform.
29 AP-75171, Rev. 1.1, 25/06/04