11. User Maintenance
11.12. Replacing Cutter (2/2)
Replacing consumable parts
Replacing Cutter
1.
Step (3/3)
[7]
[8]
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.133)
Tap [Enter].
Tap [Home] to end the cleaning process.
11.13. Replacing the cleaning wiper (1/2)
Replacing consumable parts
Replacing the cleaning wiper
The cleaning wiper is an essential part to make printing consistent. Please replace it
periodically.
Replacing period:
・
Approx. every six months
Preparation
・
Plastic gloves, glasses, mask
・
Absorption material for the flushing box
・
Paper you can get dirty (paper which ink will not bleed through)
・
Wear the protective gloves ・glasses ・mask and avoid contact with your eyes or
skin.
Eye or skin contact may cause slight irritation or bloodshot eyes.
If in eyes or on skin, immediately flush with water.
If irritation is present, seek medical advice/attention immediately.
1.
Step (1/3)
[1] Put the printer into the CR maintenance mode.
[2] Open the front cover.
[3]
[4] Cover the platen with the paper you can get dirty.
Ink may drip from the cleaning wiper.
We recommend covering the floor with paper as well.
Page.
118
To Table of Contents
cf. Operation Manual(Rev.01-p.134)
Open the maintenance cover on the right side.
CONFIDENTIAL