Replacing The Lever Sensor Assembly - MUTOH Rockhopper 38 Maintenance Manual

4.4.4. Replacing the Lever Sensor Assembly

Remove the Front Paper Guide. Refer to "Removing Front Paper Guide"
Step 1 :
Remove the Unit Panel Cover. Refer to "Removing Unit Panel Cover"
Step 2 :
Remove the Right Cover. Refer to "Removing Right Cover"
Step 3 :
Open the Control Box. Refer to "Opening and Closing Control Box"
Step 4 :
Disconnect connectors J104 (lever) from the Main Board.
Step 5 :
Remove the Panel Cable Connector and Tube Guide (1 fastening screw) and disconnect
Step 6 :
connector J301
Remove the Panel Mounting Plate (2 fastening screws).
Step 7 :
Open the two cable clamps, one attached to the front X reinforcement and one beneath the rear
Step 8 :
felt.
Nr. Description
1 Connector J301
3 Tube guide
55
Rockhopper 38 – Maintenance Manual
AP-74038, Rev. 1.1, 25/01/05