Replacing P_Edge Sensor Assembly - MUTOH ValueJet 1604 Service Manual

VJ-1604 Maintenance Manual

4.8.11 Replacing P_EDGE Sensor Assembly

1. Remove the head cover.
"4.8.7 Removing Print Head Cover" p.4-111
2. Detach the connector to the P_EDGE sensor assembly from the CR board assembly (J208).
"4.8.3 Replacing CR Board Assembly" p.4-107
3. Remove the screw (1 piece) that retains the P_EDGE sensor assembly.
No.
4. Detach the cable of the P_EDGE sensor assembly from the clamp (4 pieces).
Left lower view
2
No.
5. Replace the P_EDGE sensor assembly.
1
1 P_EDGE sensor assembly
2 Screw that retains the P_EDGE sensor assembly
(P tight cup screw M3
1 Cable of the P_EDGE sensor assembly
2 Clamp
Part name
×
6)
2
1
Part name
4-121
4 Parts Replacement
2
Upper view 1
Rev.-05